Emergency Battery Packs

SELECT DEPARTMENT

Embassy Series - Micro Inverter

Emergency Lighting Micro Inverter
The CSC-S-20 micro inverter is a battery-powered backup device that provides emergency power to a connected lighting load up to 20 W. CSC-S-20 is the ideal emergency backup for screw-base LED lamps and a superior choice for office, retail, hospitality and similar spaces. When normal power fails, the micro inverter immediately begins supplying emergency power and will continue to support the connected load for a minimum of 90 minutes. Upon restoration of normal power, the device automatically returns to the charging mode, and the inverter battery is fully restored in 24 hours. A solid-state low voltage disconnect circuit protects the battery during prolonged power failures. CSC-S-20 allows fixtures to be on, off, switched or dimmed. It supports 100% of AC rated output throughout its 90-minute runtime so fixtures operate at full brightness during emergency operation. The device provides power to the input side of the fixture, including the ballast, and is designed for use with indoor and outdoor applications.

Read More >>>
Embassy Series - Low Profile

Low Profile For T5 or T8 Flourescent Lamps
Embassy fluorescent ballasts allow the same fixture to be used for both normal and emergency operation. In the event of a power failure, the emergency ballast switches to emergency mode and operates one or two of the existing lamps for a minimum of 90 minutes. Each emergency ballast contains a battery, charger and inverter circuit in a single package. The emergency ballast can be mounted in the fixture wireway or on top of the fixture, and is UL listed for factory installation or retrofit applications.

Read More >>>
Embassy Series - Linear & Compact

Linear/Long Compact or Compact Fluorescent Lamps
Embassy fluorescent ballasts allow the same fixture to be used for both normal and emergency operation. In the event of a power failure, the emergency ballast switches to emergency mode and operates one or two of the existing lamps for a minimum of 90 minutes. Each emergency ballast contains a battery, charger and invertor circuit in a single package. The emergency ballast can be mounted in the fixture wireway or on top of the fixture, and is UL listed for factory installation or retrofit applications.

Read More >>>
SELECT PRODUCT DEPARTMENT: Emergency Ballast
Copyright 2013 Mule Lighting® | All Rights Reserved | 800-556-7690 Terms of Use | Site Map
Mule Lighting®     46 Baker Street, Providence, RI 02905    Phone: (800) 556-7690    Fax: (401) 941-2929